Because my car is a RHD I tapped into the CAN bridge at the bottom of the drivers side A pillar, rather than following the instructions to use the passenger side one. In all it took about 9 hours to do, although I was going slow as hadn't removed many of the bits of trim before. Got it installed in my A4 B8.5 Avant and calibrated. Make sure 6C is ticked in CAN gateway Installation list. The Reverse Camera will now be the default when reverse is selected and the OPC display will show on the right side over the camera image. Once Coded you need to go into the Parking Sensor Menu on the MMi, then disable Display and then re-enable the display (This is very important!) If bit 4 is not available as it was on mine, select "LCode2" on the top menu which should allow you to select Bit 4. With VCDS go to Controller 09 Central Electrics, then Long Coding, Long Coding Helper. The RVC controller has no component protection so that a relief.Ĭoding tip taken from another thread on here (thanks ) It turns out Controller ending D is not compatible with B8/8.5 platform, I’ve managed to source a C Controller from the US decent money. I’ll keep updating this thread with info gathered from my research
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |